Post by Deleted on Jan 10, 2017 13:06:38 GMT
Just had a reply from the Denmark as follows:
Dear Richard,
We assume you need gaskets for N.C.BJERG windows.
NCB went bankrupt and closed back in 1997!
None of NCB aluminium extrusions exist today, and very few spare parts are available.
N.C.BJERG windows have 4 types of gasket, link: www.ertec.dk/picgasket.htm
Type 1: The most important gasket regarding water tightness ... but it can not be replaced.
Gasket type 1 and the glass are both captured inside the outer frame, and can not be taken out!
Type 2 : Used in NCB opening type windows. Type 2 does not exist any more.
Type 3: Sponge gasket (types 3a, b & c) between the inner and outer frames...has no influence on water tightness.
Type 4 : Important for water tightness.... lays between the hull and the window.
Gasket no. 3 and 4 are the only gaskets that you can replace.
BUT If your windows are leaking replacing gasket nr. 4 (or 3) wont help very much, since most of gasket no. 4 is under the frame, and normally in good condition.
In 99% of the cases new windows are the only lasting solution.
Short term repairs with Sikaflex can also be considered, but only if the outer frames are not corroded!
If you like to experiment with the gasket replacement please order them from our dealer.
Here are the links to the webshop.
Gasket 3a: www.hr-parts.com/contents/en-us/p679.html
Gasket 4: www.hr-parts.com/contents/en-us/p678.html
If you decide for new windows we could produce them for you with our own extrusions (BASIS-LINE).
Best regards
Sam Shad
ERTEC Danmark ApS
Egestedvej 2B, DK-3320 Skaevinge, Denmark
Phone: +45 48 28 48 91, Fax: +45 48 28 48 92
Website: www.ertec.dk - email: ertec@ertec.dk